Laboratoire Travaux Publics, Ingénierie des Transports & Environnement (LTPiTE)
Permanent URI for this community
Browse
Browsing Laboratoire Travaux Publics, Ingénierie des Transports & Environnement (LTPiTE) by Author "Derriche, Zohra"
Now showing 1 - 3 of 3
Results Per Page
Sort Options
- ItemNumerical investigation on buried pipelines subjected to permanent ground deformations due to shallow slope failures(Jordan University of Science and Technology, 2023) Bouatia, Mohammed; Demagh, Rafik; Derriche, ZohraPermanent ground deformations (PGDs) induced by slope failures cause catastrophic damage to buried pipelines. This paper presents a 2D plane-strain numerical analysis of the behavior of a 800 mm water transport pipeline buried in the Aine-Tine slope (Mila, Algeria) subjected to shallow PGD, as it could be triggered by the recent earthquake of August 07th, 2020 (M= 4.9). The analysis is carried out through the application of an incremental displacement to simulate the soil-pipeline interaction while focusing on the effect of (1) the magnitude of the PGD and (2) the rigidity of the pipeline on the structural response of the pipeline. The elastic-perfectly Mohr-Coulomb model was used to simulate the soil behavior and the elastic model was used to simulate that of the steel pipe. Pipeline deformations (i.e., translation and ovalization) and radial internal forces’ (i.e., axial forces FA, shear forces FS and bending moments MB) results highlighted that shallow PGD can exert additional loads on pipelines that are proportional to the magnitude of the PGD. It has been found that the soil deformations as well as the internal forces induced on the pipeline ring are higher for rigid pipelines. Moreover, the results indicated that rigid pipelines are more effective than flexible ones as far as ovalization-serviceability limit state is concerned. In effect, for PGD magnitudes of 0.5, 1 and 2 m, the ovalization values of the flexible pipeline are, respectively, higher by 23%, 21% and 18% than those calculated for the rigid pipeline. Through a simplified linear numerical simulation such as that presented in this study, engineers and planners could be guided to foresee the possible causes of pipeline leaks and the mechanisms of ruptures that lead very often to severe disruption of pipelines’ normal operation.
- ItemPlastic bag waste modified bitumen a possible solution to the Algerian road pavements(Taylor & Francis, 2020) Nouali, Mohammed; Derriche, Zohra; Ghorbel, Elhem; Li, ChuanqiangMany Algerian road and highway pavements suffer from severe premature degradations that appear in the first years of their in-service life because of the insufficient performance of the asphalt pavement materials. This study examines the suitability of using plastic bag waste as a bitumen modifier in order to improve the behaviour of asphalt mixes. This paper analyses the effect of adding plastic bag waste; low density polyethylene (LDPE), to a conventional 40/50 graded bitumen. Basic rheological parameters such as penetration, softening point, ageing (RTFOT) and storage stability were used to determine the plastic addition resulting changes on the modified bitumen, expressed relatively to the pure bitumen basis. FTIR spectroscopy was also used to study the chemical functionalities present in the modified bitumen. It was observed that the penetrability of the waste plastic modified bitumen (WPmB) decreases and its softening point increases. Consequently, its thermal susceptibility and its aging rate decrease. Performances of the WPmB were then determined on an asphalt concrete mix (AC) in terms of mix compaction behaviour, stiffness modulus and water resistance ameliorations. Results obtained show that adding plastic waste to the pure bitumen allows reducing void content of the mix and increasing substantially its stiffness modulus and water resistance.
- ItemStrength development and lime consumption progress relationship in lime stabilized bentonite samples(Springer International Publishing, 2021) Gueridi, Fatima; Derriche, ZohraAlthough soil-lime treatment has been successfully used for a long time, the mechanisms behind the clay soil-lime reaction remain insufficiently understood until today. Improvements provoked by lime addition are observed immediately on the soil texture that passes from a plastic state to a coarser state. Strength gain, which corresponds to the advancement of the pozzolanic reaction, develops as a long-time process. Strength development of lime stabilized clays has been extensively studied but investigations on lime consumption progress are scarce. Experimental results related to lime consumption progress, strength development, and pH evolution over time in lime-treated bentonite samples are used in this contribution to shed some light on the clay-lime reaction mechanisms. Results obtained indicate that the short-term and long-term reactions take place sequentially. The short-term reaction occurs at constant pH, lasts about 3 days producing only a limited strength gain. The long-term pozzolanic reaction develops much of the strength gain, which occurs in line with lime consumption and is accompanied by pH value decrease starting from the pH corresponding to the initial consumption of lime (12.65) going down to 11.5 after a long curing time. Based on the results obtained, a strength and lime consumption relationship similar to that that has been shown to exist between strength and the volume of the reaction products formed in cements is defined. XRD results do not show cementing minerals’ peaks but pozzolanic reaction occurrence is evidenced by decrease of the peaks of montmorillonite and silica-based compounds of the studied bentonite.